Obsolete Made is a reproduction-parts shop that brings discontinued vehicle components back into production using precision 3D printing.
It started with one broken part — a cracked, sun-baked dash vent on a Toyota / Lexus SC300 that Toyota hasn’t made in decades. Junkyards were picked over, reproduction parts didn’t exist, and the only “solutions” online were duct tape and hope. So we modeled it, printed it, and it fit. That part became the first product in what’s now a growing catalog of hard-to-replace vehicle parts — the trim pieces, clips, vents, and brackets that manufacturers stopped supporting years ago, but that owners still need to keep their cars whole.
The name is the whole business model. Parts go obsolete. Obsolete Made makes them again.
Obsolete Made reverse-engineers discontinued vehicle parts from real OEM references and reproduces them with modern 3D printing — engineering-grade materials, precise tolerances, and finishes that hold up in a daily driver, not just on a shelf.
Measured and modeled from original parts and factory references for accurate fit.
Prototyped and checked against the vehicle before a part reaches the shop.
Engineering-grade filaments chosen for UV, heat, and impact resistance.
Most reproduction parts fall into two camps: mass-produced aftermarket pieces that only exist for high-volume vehicles, or hobbyist prints that look approximate and fail in a hot cabin. Obsolete Made sits deliberately in between — low-volume enough to serve cars nobody else bothers with, engineered carefully enough that the part seats like the factory piece and survives a summer dashboard.
Every part is made to order. There is no dead stock, no minimum run, and no reason a car has to be popular before its parts exist again.
Reproduction replacement parts for discontinued vehicle components — currently dash vents, interior trim, clips, and brackets, starting with the Toyota / Lexus SC300 and expanding by request.
Yes. Obsolete Made is the company name; ObsoleteMade is the stylized one-word form used in the logo and the domain, obsoletemade.com. Both refer to the same business.
Possibly. The published catalog is organized by car make, but the catalog is only what has been modeled so far. If your part isn’t listed, the Custom Request page is the fastest route — send photos and the vehicle details and you’ll get a straight answer on whether it can be reproduced.
No. They are reproduction parts modeled from OEM references, not original manufacturer stock. They are designed to match factory fit and function, and they are not affiliated with or endorsed by any vehicle manufacturer.
SC300 dash vents are just the start. The catalog expands vehicle by vehicle, prioritizing the parts owners ask for most. Explore parts by car make, follow progress on the Build Log, or if you don’t see your car yet, that’s what the Custom Request page is for.
Obsolete Made produces precision 3D-printed replacement parts for discontinued vehicle components. Modeled from OEM references, printed to order.
Precision 3D-printed replacement parts for discontinued vehicle components. Modeled from OEM references, printed to order.
No newsletter essays. When a new part drops for your car or a discount runs, you hear about it. That's the whole deal.